The possibilities are endless!
>>33859334
That looks so much worse than I imagined.
>>33859334
>tfw there is a Traditional Rifle lower for an AR-15
>But there isnt a Traditional Rifle upper for an AR-15
y tho
>>33859343
I know.It sounded so good in thought but in life it looks awful.
>>33859334
That won't work for any of the straight blowback uppers though, will it? Because the AR-57 upper would be pretty funny on that.
>>33859359
>>33859343
Because they used parts that look like total fucking ass.
If one used a proper upper with low profile ironsights and a decent foreend paired to a better looking stock (protip; Remington 1100 stocks fit) it would look fine.
>>33859355
What would a Traditional Rifle upper consist of? Low profile gas block and a drilled and tapped slick upper with no rails nor irons?
>>33859378
No, leave the rail, but low profile folding irons would be needed.
>>33859391
Think of how sexy slick upper receiver with rounded corners and so on would look though.
>>33859378
The thought of it makes my wee wee hard
>Rifle length gas
>low profile Gas block underneath a wood hand guard and heat sheild
>iron sights are old hunting style
>Upper is a cut down Pre-A1 drilled and tapped for a rail
>No dust cover
>Chrome BCG
Muh dik
>>33859378
I'm envisioning a handguard similar to the factory Vepr one, blued steel continuous-taper barrel in either blued or stainless receiver (or one painted to look like blued or stainless, cuz aluminum) with permanently installed low profile iron sights.
Top of receiver is either slick+rounded and drilled and tapped for 2-piece scope bases, or has a lower profile milled Weaver rail instead of full picatinny.,
Right hand charging handle. For sure.
>>33859334
put a Shrike on it
>>33859446
A problem with the Vepr style handguard is that the AR gas tube is hella unaesthetic, maybe a simple sheet metal cover as a part of the handguard could remedy that problem though.
>>33859492
And look fairly cool to boot. Imagine a long AR-15 with a short, beefy handguard through which a parkerized barrel runs and a similarly parked gas tube cover returns through mounted with a very small gap between it and the barrel from the gas block, which has a low profile hooded post. Put a ring aperture at the very rear of the receiver and a side-charging handle.