How do I fix this shit?
I don't mind it normally but I have a Cowitnessed red dot and it bothers the shit out of me that it's not centered.
Do I just smack the ever loving fuck out of it to one side?(probably not gonna be this)
>>31183684
Aw shit. Now my phone is having a canting problem of its own
>>31183684
It is pinned in place after it is press fit to the barrel. You would have to press out the old pin then align it properly, press it back on then drill the hole again slightly oversized for an oversized pin. You might also have to un pin and press off the FSB and gas block just so you could access the and press off the RSB. It would be a lot of work to just to satisfy your autism about it being centered. It would probably cost a couple hundred at a gunsmith to have him do it, you could do it for less yourself but it isnt going to be easy
>>31183684
>Not making sure your sights are perfectly squared before you buy the rifle.
>>31183782
This. Front sight posts are a bit easier. Rear sight is a bitch. As long as the rifle can be zeroed I'd just learn to deal with it if i were you OP.
>>31183684
Ya gotta whack it with a rubber mallet.
Careful that the whole barrel isn't just torqued... Does the front sight look canted too? Mind the gas tube /op rod fitment
>>31183782
Fuck
>>31183684
What's the gun op?
>>31183928
All you would need in terms of tools is a hydraulic press and a drill press, then some misc hand tools and bits. The actual pin itself is not expensive. It would still be more of a pain in the ass than it is worth though and probably would take several hours.
>>31183977
not op but judging by the internal mag stabilizers instead of mag dimples, and the metal shavings all over the inside of the receiver it is a WASR 10
>>31184122
Ding ding ding!
It's not just any WASR, it's the hottest WASR :^
>>31183684
What rifle is this?