Thread replies: 11
Thread images: 3
Thread images: 3
Someone was working on a 80 percent sig made a few post then stop updating.
>sad anon wanted to see this get done
>decide if you want something done you have to do it your self
>I am willing to Khyber pass this gun using hand files or what ever I can use to machine this shape or even do it like the Philippinos do and take a tamplet of the gun and copy it by hand
>only problem is I live in California and finding someone wit one of these guns to get measurements to reverse engineer it is impossible
So any anon with a sig p250 that can give measurements and what type of steel to use when making it so either me or who ever can do it first can build ghost sig p250 or better yet p320.
>>
Bump for interest.
>>
This would be a pretty awesome 80% setup as Sig sells all the parts you'd need to complete it.
>>
>>29797694
I looked at this briefly when I owned a 250.
the same could be done with a Kel-Tec I would think.
>>
>>29797694
this is interesting
>>
I'm pretty sure this peetered out over time. polymer80 is selling 80% glock frames that can be built in a range of calibers atm. Might seem a good route being in an anti-freedom state if you just want a handgun. Wish I could help on the sig though, castings of the unfinished receiver were on gb for a little while iirc.
>>
>>29801790
No interest in just a handgun I know this can be done and I wanna see this done.I ordered my polymer80 glock months ago I am getting it tomorrow
>>
>>29803557
Do a thread on it.
>>
>>29805126
Tomorrow when I get it.also my parts won't come till much later sobi will just take I pic I will see if I could finish it using files and hand drill
>>
>>29805190
Cool, looking forward to it
>>
B-b-b-b-b-bump the thread
Thread posts: 11
Thread images: 3
Thread images: 3