So, I'm trying to mod a case I picked up for 10$ (I'm a baller like that) It was an older full tower case but I figured I'd bust out the dermal and make it mine. If I screw up meh, It's 10$.
I ran into a issue. The case only "Supports" 80MM fans. This must change. I want to install 4 120s into the case. So I figure I will just start drilling extra holes and calling it a day.
My question is. Do you know if a site that has templates for a 120mm Drillout? I've been googling for about 30 minutes and all sites the .jpg is dead.
just get the holes tapped by a pro
>>60848712
Can't do that. This is a side project and the wife is allowing me to do this as long as I do not go nuts on the budget. lol (Baby on the way)
Just use some 120mm grill as a template
>>60848559
if you can't find anything just buy a $10 120mm fan and trace it's holes onto a sheet of paper, then drill through the paper and your case. Make sure to start with a smaller diameter bit and drill pilot holes if you're trying to make larger (than 3/8in) holes and work your way up from there, they'll turn out cleaner looking.
>>60848559
Lazy ass.
https://mnpctech.com/pc-cooling-fan-templates.html#/cmsPage/50