So trying to wire my rc toys slide switch to a newer one that fits a mount on it. Problem is, it's a 3 stage switch 6 pin, so it has 3 selection settings as apposed to the old on/off selection setting 6 pin to the left you see here. I got 3 main cables, the negatives, the control board positive and the battery positive on the far right. Since I'm trying to rewire it onto the 3 selector, how would I go about doing so so that it's still an on/off switch. I'm still a novice at requiring as I blew up a battery in my face yesterday. Got a multi meter for that now.
ask /g/
use meter to figure out how old switch works
use meter to figure out how new switch works
resolder wires so behavior of new switch is the same as old switch
Yup figured out the way the current flows, I looked up the type it was like 3A250V I think, searching led me to this diagram. Confirmed it with my multimeter. Gonna solder it later.