How can I flatten this thin sheet of metal?
>>1053419
sandwich between two metal blocks and then bang on it
https://en.wikipedia.org/wiki/Rolling_%28metalworking%29
>>1053421
> then bang on it
Think that would be hard for op when he has no one to bang
>>1053452
Any fat chick will do.
heat it with a torch until it's really hot then sandwich it between two flat objects (like concrete blocks or metal plates) and put some weight on it.
Flatening a thin sheet like that can be very difficult(depending on your definition of flat) if you fully anneal it and press it in a hydraulic press between flat plates it will get pretty flat, but you may be better off using a rubber mallet and a judiscious eye...
>>1053419
What is it for?, if it's not for food use why not just buy a new flat piece of metal.
>>1053837
no, you need a flat girl
you can't use a curvy chick to flatten metal, it would be all crooked and shit
>>1053419
dutch oven
>>1054742
The fat ones only have one curve so you might have a convex sheet
But the thin ones are curvy all over, you'd probably end up with like an S shaped plate