You are my last straw boyz

windows 10?

The vast majority of atmel USB programmers basically don't get recognized by windows 10. Legit and fakes.

I can program the mcu's int atmel studio just fine, but I can't burn the bootloader. Since in can read out that the connector is reversed I don't think it's a driver issue.

hmmmm, I just flashed a hex file to my atmega with avrdude and everything works fine... Guess the arduino ide fucks some command up

>>1045171

Why would you buy a flash programmer and then use it to flash the arduino firmware?

The point of a flash programmer is to skip arduino and use C with debugging

why didn't you just buy a cheap knockoff

>>1045263
not op but would like to use atmel studio instead of arduino ide. should i just get any avr programmer off aliexpress/ebay? any specific good ones?

>>1045275

The best board by far is the atmel Xplained Mini.

It's like 10 bucks and it's fully supported. Also it isn't a cheap knockoff because it comes from Atmel (or I guess microchip now?).

>>1045263
I already had it, I just want to try out the arduino bootloader.

File: iWKad22.jpg (36KB, 432x324px) Image search: [Google]

36KB, 432x324px

>>1045287
oh boy

>>1045287
Why?

>>1045171
run as admin or
reinstall Arduino IDE and drivers.

>>1045632
if you are already programming with ISP there is literally no reason to use it.

its only use is the wait for usb asp programming at boot. making boot a few seconds instead of almost instant.

I'm an analog/logic fag who isnt all that into mcu.
but if im gonna go mcu i use atmegas programmed in the arduino isp.
but i use isp and no bootloader