Hey all, just wanted to showcase an incredible Helm of Saint-14 3D print. I had purchased this to be used as a showcase at my Comicon stall while I travel around and it turned out even better than I had imagined...I will post a series of pictures in the thread.
That being said, it gave me an idea...If I was to reproduce this helmet out of EVA foam to wear, I can't quite figure out how to safely give myself vision without causing any aesthetic changes.
Can I get some thoughts please as I post?
>>9285121
This is the view from the front and my EVA foam problem I need help with
>>9285121
>Can I get some thoughts
First of all: you don't need your own thread.
>>9285125
Ignore this dude, it's clearly too early in the morning for them lol.
I dont know how you would get around those big face plates actually. If you cut small holes it would look silly and I assume the center isn't supposed to be much wider. Not sure what you can do bud, but that's a cool helmet
>>9285130
OP here, yea I guess so haha
Maybe I'd have to change the design of the helmet after all...A bummer if that's the case