Hey /adv/
I'm new when it comes to box mods and was lucky enough to get an IPV D2 and uwell crown tank
Just put in the 0.5ohm coil that came with it (stainless steel, dual) and noticed something off
I could run the 0.25 coil up to 60W no problem, but cranking the 0.5 up to 30W, the mod reads the voltage as 4v
My battery is 3.6V so I shouldn't exceed that, right? Do I just have to run this coil at a really low voltage and compromise on, well, everything? Or am I just retarded?
I ordered in some more 0.25s anyway, the reading never exceeded the battery voltage even at 70W
Anyone?
It's a regulated mod so I can't go too far wrong, surely
Help would be greatly appreciated
Basically I just want to know if it's ok to run my mod at higher than the 3.6v on my battery (around 5v to get to my desired wattage)