I recently removed a wood furniture stock set from my Mossberg 500 and put the factory furniture back on the shotgun. I noticed, however, that the stock has spacing issues now and the stock moves back and forth(pic related). I have all the factory spacers on the stock so that isn't the issue. If I were to shoot this would there be any issues?
>>31851600
Not trying be THAT guy, but did you tighten the bolt down all the way? I've replaced a lot of 500/88 stocks and I've never encountered this.
>>31851600
yes there would be issues. there is probably some crap left from the wood stock you didnt remove. take it off reinstall make sure all the washers are present. are you reusing the same bolt? there may be size differences depending on the age of the old wood stock and the new replacement.
>>31851642
I used the bolt that came with the factory new gun on the wooden stock.
>>31851639
I tightened it fully, yes
>>31851659
Did you remember to close the action when you tightened the bolt?
Check the rising cantilever bolt just before the stock is reinstalled,
Could also be that the reverse crush washer is bent backwards
>>31851659
are you sure you didnt lose a washer?