Hey there DIY, I have a question for you guys. So I bought this Jiu Jitsu dummy at a yard sale, normally these are pretty expensive but I got it for like $25. It seemed pretty good except that it’s not completely filled in some areas so I figured I’d get some scrap cloth and beat it/press it into the dummy with a baseball bat and fully fill it. Well I tried for about 6 hours and could just never get the lower legs to fill to a point where I was happy with it. The lower legs were filled at the factory and are hard, but the upper legs no matter how much I tried to pack in scrap cloth would never get to that same cloth density as the lower portion. I believe that they probably used a hydraulic press to achieve this level of fill density. I’m thinking about getting a 20 ton shop press at some point and maybe using a baseball bat as a die of sorts to compress the material into the legs/dummy. Would this work? Would you guys have any other ideas for me either how to fill it without a press or tips for filling it with a hydraulic press? Stuff to watch out for? Maybe how to avoid tearing the dummy material with the press?
Err could never get the upper legs filled to a point where I was happy with it, the lower legs were fine*
I would install a fleshlight.
That said, look up how to stuff a duvet. I doubt you would struggle to fill it with 100kg of cloth by hand.
I'll take a look at that, but honestly I tried smacking it with baseball bats, shoving in more and more cloth with the tip of small wooden dowels etc nothing could get it compressed enough. I really think the shop press is the answer.
>>924160
>I would install a fleshlight.
thats the fuck im saying
its like a sex doll you can also fight