I need some advice on a project I'm planning to do. I want to make a metallic trainer butterfly knife based off of the one in CS:GO (pic related) but I don't really know how to make the handles properly. Primarily I need advice on making the parts of the grip which keep the blade inside so it doesn't peek outside of the handles.
>>1116457
fuck you kevlar batman poster
Mock it up in timber first so you can figure out the blade-handle dimensions that are a good fit, then once you're happy with that= make it out of metal
Start with a standard butterfly if you aren't familiar. Otherwise your Knuckles are going to look even more like ground beef than they would otherwise.
Anyway, easiest solution is making each handle out of 3 pieces.
>>1116464
the best lolcow in /diy/
>>1116464
Not OP here but fuck you, man. I will take him and his knife down.