Hi /diy/. I have a bit of a pickle. I have this seven port USB

>>1006894

sounds like your chip failed, and there's no reasonable prospect of spontaneous revival unless you can get Jesus to lay his hand on it.

death: it's part of life for both man and silicone.

>>1006907
Well, my soldering iron arrives tomorrow. I guess I will rip and tear it off the board.

you're gonna fuck it up with the soldering iron. even experienced people have trouble with SMT components. fortunately, it's very easy to just cut the pins one by one: press down with an x-acto knife. you can leave the discarded pins behind, or scrape them away getly using the iron.

>>1006934
Does it really matter? The USB2 end is separated from the USB3 end, all I have to do is wick most of the solder off the pins, pop the chip off and wick the pads.

>>1006934
Fuck you're stupid. I solder for work and do shit like this all the time. Throw some flux down and hit it with two soldering irons and you'll be fine.

File: how not to solder2.png (337KB, 584x388px) Image search: [Google]

337KB, 584x388px

>>1006941

fuck you're smart. because you have the right tools and experience, it automatically implies that some noob without either of those things will be successful at a delicate job the first time out.

>>1006959

it's a little finicky but if you play around with it a little you can get it to work with a single soldering iron and some small tweezers.

It's a good experience to have, so he isn't intimidated by SMDs so much anymore.

>>1006907

Silicon. Silicone is the squishy stuff.

>>1006959
It's a fucking USB hub, if he fucks it up then so what? It's a good opportunity to learn/practice.

>>1006934
Don't do anything because you may fuckup. God I hate people like you. What the fuck does it matter if he rapes his chip. Hell even if he rips pads off the board its better for him to learn on cheap shit like this.