Thread replies: 3
Thread images: 1
2016-02-05 18:08:32 Post No. 512008
Post No. 512008
Hello, new architect here. I don't know if this is the right place to post this or in /p/.
I measured this church and designed it in AutoCAD (seven layouts).
I want to turn it into 3d in 3dsmax. I don't have any problem modeling, but when it comes to texturing I don't know what to do.
The inside of the church is full of curves that have hagiographies on them.
Is there in the market some kind of photocamera-scanner that can scan the curved hagiographies and make flat images of them so that I can place them on the unwraped surfaces.?
How should I deal this problem?
Again, sorry if this is the wrong board.