Is it possible to unsolder a CMOS sensor from one mouse, solder

Rather than trying to desolder 8-16 pins and possibly not fixing the good mouse anyway why not just take the micro switches out of the shit mouse?

Not unless they're one to one compatible. Why not just fix the broken buttons using the ones from the good one and macguyver it.

Might just sound way too picky, but I never liked the feel and surface of the good mouse, it's glossy and white so it gets dirty every single day (yes I wash my fucking hands, almost compulsive with that) and the button section just feels cheap, it's like it is only covered in a thin plastic.

I already had to swap the usb cable because of the shit mouse having a cable shorter than my dick, which led to some moding as the connector wasn't in the correct order. So since I'm working on it, might as well go full retard on it.

The good mouse has a chip in it though, hopefully it is not to help process the scan of the sensor or that will just lead to way too much of a hassle.

Stop being poor and buy the Logitech g502

File: 1416602353803.jpg (138KB, 693x693px) Image search: [Google]

138KB, 693x693px

>>52652910
>"gaming" labels
>obnoxious design and colors

>>52652910
Clear bait.

The jig is up, on tracing that chip I found out that it doesn't access the sensor, I was about to get on with it and then I noticed that my math skills are sub par, the good sensor has 12 connections and the shit one has 8. I'm calling out on this one, thanks for the input though guys.