Stick welding thin material

>>935563
Personally I would never weld anything under 2mm using an arc welder, but if you are adamant try finding some 1.6mm 7014's to use. Do a quick google search and you should find heaps of forums with people asking pretty similar questions.

You can try buying thinner sticks, like the other anon said, otherwise stick with the 2,5mm. A technique that works fine is doing small spots along the weld and then do a pass over them.

>>935613
This. Make sure it's cool before welding on it again. Also, use DC negative for less penetration. I'd use MIG or TIG for something like that, but if all you have is stick, good luck. I've done similar stuff, but it's tricky.

File: IMG_20160125_142638956.jpg (1MB, 1456x2592px) Image search: [Google]

1MB, 1456x2592px

>>935613
>>935618
OP here. Tried the small spots technique with DC positive (60 amps) using 2,5mm 6013's and it worked fine, pic related.

Thanks for the tips.

>>935855
>Dat porosity doe

Heres a trick i use a lot, get a thick piece on the side get a small bead on the thick piece and then change to weld the thin one, what really fucks up your weld, is the heat build up on such a thin material, but with the tip already hot, you get a small bead and let it cool, repeat the process

>>936810
>obvs due to lack of shielding gas :3

>>936810
That's not porosity, that pick marks from when op attempted to chip the slag when it was red hot

>>935855
>>937129
seriously guy, use that to scrape it AFTER its cooled.