>>926005 The proper technique is to get some new pads and super glue them to the board, then electrically bond them to the original traces. Then solder your new component down.
The ghetto way of doing it is to use an xacto knife to scrape some of the green solder resist off of the remaining traces, then solder wires to them, then solder your new SD card slot to the wires, then super glue the SD card slot on to the board. You can expect slower data rates though.
All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.
This is a 4chan archive - all of the shown content originated from that site. This means that 4Archive shows their content, archived. If you need information for a Poster - contact them.
If a post contains personal/copyrighted/illegal content, then use the post's [Report] link! If a post is not removed within 24h contact me at firstname.lastname@example.org with the post's information.